Venting issues

See that white thing just above the back object? That is the boiler vent. The object just above that is the water spigot, and if you look up toward the corner along the same wall you can see the woodstove air intake. Still buried is the intake/exhaust for the HRV unit. I was able to stand on the snow and easily touch the roof

Our car. We got a near record amount of snow for a March storm

This morning we were awoke by the not-quite-full-on smoke alarm signaling intermittently. Not smelling smoke we quickly opened the doors and a bunch of windows in case it was a CO alarm, which it actually seems to have been.

We quickly ascertained that the boiler vent had been covered over by the prodigious snowstorm we experienced last night and today. The boiler is able to detect when the vent is blocked and will shut itself down which would prevent an accumulation of CO.

I suited up and went out to shovel the vent out. The amount of snow covering this thing was stunning. What was curious was the fact there seemed to be a bit of a bubble, for lack of a better way to describe it, around the vent. In other words there was a non-snow space that I shoveled into when I got near the vent pipe. What this makes me think is that the heat of the boiler vent gas was kind of creating its own little pocket under the snow and perhaps this was the reason the boiler seems to have not actually shut down, hence the CO alarm.

With the vent cleared and the house thoroughly aired out we shut the doors and windows and felt okay about the situation. It was a bit later that it occurred to me to check the HRV air supply duct as well. Like the boiler vent, it was also burried, and like the boiler vent it seemed to have it's own little air-space pocket in the snow once I reached it. Like the boiler vent it is venting warm-t0-hot air, so it makes sense.

We take this stuff absolutely seriously; I was aware of these potential problems when the installation work was done, but I got a bit of resistance and didn't push further about locating the venting higher up. I wish I had. The task now is to correct it.

To that end I'd already put in a call last week to the plumber about the situation, so we are going to correct it. On the upside, we are grateful for the alarm system and glad it works.

About that spider...

So, I led off the last post with a suggestive title about a spider, but didn't explain. I was pretty bushed when I wrote it and decided I get back to it later.

Here we go:

In the wee hours of Saturday morning, sometime around 3:00am, Nancy and I were fast asleep when we were jolted awake by the piercing wail of the fire alarm. In a flash we'd opened windows in case there was an accumulation of CO (which our units detect, along with smoke). We didn't smell any smoke and couldn't sense anything suspect in a quick survey. The alarm stopped in a few seconds.

We then spent a short time locating the written directions that we'd stored away. Nancy rooted around out in the yurt and found it. Upon examination we discovered it was the Spanish edition. Caramba! No sign of the English version.

Next up we found our model on the Internet and we're able to understand the blinking red light next to the "smoke" label. A push of the button cleared the unit back to green. While up on the ladder examining the detector I noticed a small brown spider perched in one of the small openings to the interior. Nancy had read through the various possibilities for a false alarm and among them was the presence of insects. It seems this little critter was the source of our troubles.

The electrical code requires hard wired alarms on each floor of the house and there is a battery in each unit in the event of power outage. Because we have a boiler and propane gas cook top in a very tightly built house we had Felton install CO/smoke alarms on each floor although the requirement was something less, perhaps only a CO detector in the vicinity of the boiler and smoke alarms in other areas.

I tried to get the spider but had no luck. As far as we can tell, he or she is still there and I'm not sure what we're going to do about it. This event got me wondering if there might be a fine-mesh screen around the alarm that wouldn't interfere with it's function. I'm going to write the manufacturer and ask about that.