Wednesday, March 10, 2010

Plumbing continues

How to get a pipe in the house. Note the second hole to the left of the pipe

The pipe in place on the inside, one each through the two holes on the outside

The rigid insulation in the basement. You'd be surprised how many times I've whacked my head harder then I'd like on that white plastic pipe coming out of the wall.

I've been plugging away at the drain and vent lines.

What surprised me was that in order to get certain lines into place in the floor joists, you have to continue your line of holes right out through the side of the house. What do you do if you've built a house out of concrete?

I've been enjoying the plumbing work; you basically have a pile of fittings and you dry-fit them together with lengths of PVC pipe and when everything is good and they are pitched the way you want them, you glue them all together with nasty smelling solvent glue.

I've also been continuing with the insulation of the basement in advance of our HRV unit being installed. (HRV stands for Heat Recovery Ventilation and is the mechanism that will supply us fresh air, since the house will be highly air-tight and super-insulated. Without this system there'd be no opportunity for fresh air to enter the house, or stale damp air to exit. More on this later.)

Anyway, the HRV unit will be installed soon in the back corner of the basement and I want to have the insulation in place so I'm not trying to fit it behind the unit after the fact. Putting up the insulation requires hanging sheet plastic from the sill , taping the overlap seams of plastic (the red tape in the photo), then cutting the boards of insulation to fit over the pink board coming up from under the slab. I then drill a pilot hole through a piece of strapping and the insulation into the concrete and finally screw a concrete screw to hold it in place.

3 comments:

Unknown said...

Too bad you have to cut holes in the roof now for the vent pipes. Make sure Paul glues everything together!. Remember his bathroom saga.

dcain said...

Hey Dave,

Don't worry, we had the pipes through the roof already. We just had to hook into them.

And yes, all joints are glued!

Tony said...

Dave, this is a late comment, but I was wondering if you will write any more about the HRV system? Thanks!